Last updated:
The heat pump runs and the thermostat says 74°F, but the house still feels sticky, and one back bedroom barely gets air. When the system is near the end anyway, it is tempting to swap the equipment and hope the problem leaves with it.
Sweet Olive installs and replaces ducted air-source heat pumps in homes across Waggaman and the rest of our service area. Before we choose equipment, we test the ducts it will push air through. Waggaman sits on the west bank in unincorporated Jefferson Parish, so the parish handles the permit. Your written estimate prices the heat pump and any duct work as separate lines, with the parish filing listed.
For a failing system, the replacement page covers the decision. When the ducts are the problem and the equipment is sound, ductwork repair may be all the house needs.
A typical Live Oak Manor replacement with new ducts
A sticky house, crushed ducts in the attic and a garage air handler: why one Waggaman replacement takes three days instead of two.

- Location
- Live Oak Manor, Waggaman
- Home
- Single-story slab home, about 1,700 sq ft, three bedrooms
- System
- Nominal 3-ton single-stage heat pump
- Ductwork
- Attic duct system replaced: new plenum, 9 supply runs
- Return
- New 20 x 25 inch return grille and duct
- Air handler
- Garage platform, new
- Line set
- 25 feet, new
- Project price
- $10,900
- Duration
- 3 working days
The setting
Muggy rooms and a tired system
The house is a single-story slab home in Live Oak Manor, about 1,700 square feet with three bedrooms. Its heat pump is near the end, and the rooms feel damp even when the thermostat is satisfied. The air handler sits on a platform in the attached garage, and the ducts run through the attic above.
The decision
The attic decides the scope
At the first visit the ducts fail the leakage test: several flex runs are crushed under old storage boards, two have pulled off their boots, and the single return is too small for the airflow. Resealing and reusing them was the alternative, but the static pressure says otherwise. We price a new duct system as its own line next to a nominal three-ton, single-stage heat pump.
- Dark circle, Each room: windows, sun and ceiling height for the load calculation
- Ochre square, Attic opening: headroom and joists
- Blue diamond, Return location: where a central return can draw air
- Yellow triangle, Electrical panel: rating, open spaces and existing load
- Open ring, Outdoor spot: footing and drainage
- Dark cross, Thermostat: on an inside wall
The work
Three days, ducts first
Days one and two replace the attic ducts: a new duct board plenum, nine insulated flex supply runs sized from the room loads and strapped so they cannot sag, and a new 20 x 25 inch return grille with its own duct. Every joint gets mastic. Day three sets the air handler and outdoor unit and runs a new 25-foot line set, brazed under nitrogen, pressure-tested and evacuated.
The handover
Measured at every register
We set the thermostat, test the drain, and record airflow and static pressure with the new return in place. Jefferson Parish inspects after the work. The aim is air that reaches every bedroom and a system that runs long enough to pull moisture out of the house.
When the ducts are the real problem
A new heat pump can't fix air that never reaches the room.
What the duct test can show
- Leakage. Air lost through loose joints and torn runs into the attic.
- Static pressure. Ducts too small or too restricted for the airflow the system needs.
- Crushed runs. Flex duct flattened under boards or storage.
- Disconnected boots. Runs pulled off at the ceiling, blowing into the attic.
- A small return. One grille trying to feed a whole house.

Three ways the estimate can go
Sound ducts stay, with a few joints resealed in mastic. Ducts with a few bad runs get those runs replaced. Ducts that fail throughout are replaced as a system, sized from the room loads with a return that matches the airflow. Our ductwork guide shows what each test result means.
Damp rooms and the size of the system
In a wet climate, drying the air matters as much as cooling it.
7.62 in
Average June rainfall at the New Orleans airport, from National Weather Service climate normals

Why oversizing works against you
A heat pump that is too big for the house cools the rooms quickly and shuts off before it has pulled much water from the air. We size from a room-by-room load calculation, not from the old nameplate. A two-stage or variable-capacity unit runs at low output for longer, which helps; the single-stage versus variable-speed guide compares them.
Leaky returns pull in damp air
A return duct with a gap in the attic draws hot, wet attic air straight into the system. Sealing it is part of the duct work. The humidity guide covers the other causes.
Working in Waggaman
West bank, unincorporated, and at the far side of our area from the city.
Waggaman runs from River Road along the Mississippi down to U.S. 90, with Avondale to the southeast and Kenner and River Ridge across the river. Because it is unincorporated, heating and cooling work is filed with the Jefferson Parish Building Regulatory Division before the work, and an inspection follows. The permit guide covers the filing.
It is also near the edge of our service area. When you contact us, we confirm the address is covered before booking the visit, and the estimate states how many work days the job takes.
Waggaman homes are generally on Entergy Louisiana accounts. The Energy Smart rebate belongs to Entergy New Orleans accounts, so we confirm your account before counting any incentive.

Pricing a Waggaman replacement
The equipment and the ducts are separate lines.
Sweet Olive's typical range for a residential ducted heat pump replacement is $4,250 to $11,750. We set your price after the site visit and write it into your estimate line by line, with any duct work priced on its own.
| What the test finds | What goes on the estimate | Effect on work days |
|---|---|---|
| Ducts sound | Joints resealed with mastic | No change |
| A few bad runs | Those runs replaced | Fits the normal work days |
| Ducts failing throughout | New plenum, supply runs and return | Extra work days, stated on the estimate |
How the duct test result changes the estimate.
Not sure whether to fix the old system one more time? The repair-or-replace guide walks through it, and the cost guide helps with a first budget.
